G
GreenNnice
Guest
can everyone give mizcris big hugs right now , sorry, mizcris, the bear was followed by the cats so, your 'favorite' animals are of my hug for your here.
And he even did it monosyllabically!
That's a sign of a true grammarian!
Yeah, or even Big Rig
They got air brakes, no freezing.
I can just see Arwen grabbin gears with a 3 speed rear end![]()
other day I seen a old 70s cadie get nailed by a 2012 honda.. cadie was able to drive away. honda was trashed.. if the hit would have been more head on by the honda driver would be dead (driver clipped the caddie at and angle) engine ended up in the passanger seat..
Oh yeah, them older vehicles like a Caddy were robustly built
Even the body steel was thicker, used to be able to use a lag bolt to mount your mirrors on
Now ya gotta use like an expanding drywall insert so it dont strip out.
Actually older semi's have problems with brakes freezing also due to condensation in the air lines. Newer rigs have air dryers to prevent this.
Automobile engineering 101:
Old car= body on frame and lots of heavy steel. The forces of a collision are transferred to the occupants since the frame doesn't bend and absorb the impact forces.
New car=unibody (no rigid frame) The forces of the impact are absorbed as engineered "crumple zones" collapse thus transferring less force to the occupants thus diminishing the severity of injuries.
Newer cars are designed specifically to "sacrifice' themselves to keep the occupants alive. Years back I drove tow trucks for a living and a colleague of mine was rear ended by a Semi. He was out for months with cracked vertebrae in his neck yet his truck was back in service that afternoon with no visible damage. The same impact speed going to a Honda would have totaled the car since the trunk would have completely collapsed, but the likelihood of the severe neck injury would have been diminished
Ok, I'm done picking on Midnight Welder for now![]()

Scary scary Arwen,
If I may make a suggestion toward your safety, theres the great possibility there could be water in the brake lines.
Over the years moisture can accumulate in them as brake fluid is Hygroscopic-(absorbs moisture from the air)
When it freezes the water it can act like a one way check valve until the water in the lines warms up and act like normal again.
It would be a good idea to have the brake system bled completely until all fluid comes out clean and clear
Bad flexible brake lines can also do this, the inner lining collapsing and also acting like a check valve not letting the brakes release.
Wouldn't want ya to get in a wreck![]()
One year ago this week (yesterday in fact) i had a new kidney put in. Its crazy to think its been a year already. My kidney is just getting broken in.
One year ago this week (yesterday in fact) i had a new kidney put in. Its crazy to think its been a year already. My kidney is just getting broken in.
They still make that stuff? :OGet it get it? Huh? Huh?
Zest....fully clean. You had that in the US right?
They still make that stuff? :O
Can't.Stop.Laughing.Noall my Zest shares fell flat. Note to self: don't put stock in soap. All your money goes down the drain.... Literally XD
I must say you appear to have more zest for life this year compared
But perhaps, you just changed soap bars?
Just incase this happens again: does pulling the emergency brake help?